Timeguard EL17 Manual do Utilizador descarregar pdf (Página 3)

Figure 2

Figure 3

Installation – Panel Mounting

For panel mounting (in panels up to 7.0mm thick with the cut-out as shown in

figure 3) the EL11/17 should be snapped into the bezel supplied and secured

in place by the use of the 2 No. 6 x 3/8" self-tapping screws provided

as shown in figure 4.

When selecting a position for the unit it should be born in mind that a

clearance behind the front panel surface of 26.0mm is required over

the full area of the panel cut-out.

The unit is designed to be mounted from the front of the panel by the

following procedure:

a. Insert the 2 bolts provided in the locations shown in figure 5.

b. Then insert the 2 No. 4 x 5/8 in self-tapping screws into the bolts

and engage thread.

c. Make connections to the unit by wires terminated in 1/4 in receptacles

from behind the panel. Ensure that the wiring is adequate for the load

to be carried.

d. Insert the EL11/17 complete with bezel into the panel and tighten up

the two No. 4 self-tapping screws. The ears on the bolts will rotate

under the tightening action to clamp the unit to the panel.

67mm

R 3.5mm

67mm

1 2 3 4 5 6 7 8 ... 11 12

Sem comentários

Timeguard EL17 Manual do Utilizador Página 3